The heating system is called a system with upper
distributing, if the PEX pipe system runs directly above the thermal devices
and from the bottom – if direct and back flow located below the heating appliances.
Even there are systems with an upturned circulation, where the direct pipeline
located below the heating appliances, but the reverse – above.
In the horizontal arrangement of PEX pipes that connect
radiators, heating system is called horizontal (or wing),
in the vertical – a vertical. There are systems bifilar,
who deviate from the risers Floor wings, and fan when the radiator
throughout the floor are connected by common distribution manifold.
radiant heating
Heating system
Heating
Heating systems come with artificial and natural circulation. In gravity systems (with the natural
circulating) fluid motion is due to the difference densities
Hot and cold coolant (hot has a lower density,
tends to rise upwards, the cold, denser – down down.
In systems with artificial (forced) heat transfer fluid circulation movement
attached to the pump. If each of the radiator coolant takes
from a straight line, and returns it to the ch return, ch the system is a
two-pipe, or a system with a parallel connection of radiators.
If the coolant passes successively through the heating devices
then such a radiant heating system called the Single pipe, or consistent.
All about floor heating
The use of modern energy-saving technologies for the production of heat by using low-temperature Low-power heaters, or leading to significant energy savings. No other type of heating other than heating the floor unable to provide such a high level of comfort, aesthetics and energy efficiency, combined with a virtually unlimited lifespan.
Dry argument can talk about many things. SPD, compared with the radiator or convector systems, saves 25 to 40% of operating costs. The amount depends on the design decisions at home and qualified designer.
Thermal comfort is achieved by maintaining the rights of thermal equilibrium between the amount allocated to the body heat and heat dissipation into the environment.
In the case of heating floor heat transfer is primarily by passive radiation of heat, which virtually eliminates the circulation of dust, which is characteristic for systems with strong convection currents (in particular, heating radiators and convectors). In addition, heating the floor surface destroys breeding ground for bacteria and dust mites. Thus, heating the floor to a large extent contribute to the creation of a favorable physiologically and hygienically safe climate in the room.
It is impossible not to touch the aesthetic side of the issue. An obvious advantage of the floor heating is the lack of visible heating equipment, removes every restriction of stylistic decisions interior.
It is important to note that the child will never have trouble or burns that can occur when touching on the radiator or convector.
A few words about the main thing
For perfect operation of any system requires the correct approach as the radiant heating system design and during its installation! Ie assembly quality depends on the human factor. For this reason, we do not use the guest labor, administered by trained shepherd. All our specialists have a higher education and high intellectual ability. To get on the job answer on a particular issue, you need to apply to any of our specialists at the facility, and not to call the office and look for someone else. We are all equal and we have a small command, we are trying through careful selection to attract people interested and trained in this area. Therefore, getting to us your interest will be considered as its own and all suggestions will be considered. You really get what you like! “And the most valuable thing you get is the right advice, you can not even doubt! Quality of our work you can appreciate only after working with us or on the recommendation of our clients. We are pleased for our work, and the growing demand for our services is an irrefutable proof of the quality of our services.
